A mill has been designed for rolling of cold deformed high precision tubes with diameter 6...15 mm from high-alloy steel, non-ferrous metals, titanium and zirconium alloys; these tubes are widely used in new technologies and machines.

Due to extended stroke of work stand the deformation degree during rolling of tubes from hard deformed, high-strength metals and alloys was increased by 8...10%, and tube feeding into strain zone increased by 50% this, as a whole, permitted to increase rolling of such tubes by 1,6. Greater length of sizing section and greater stiffness of a work stand provide tube rolling with diameter precision up to 0,03 mm.

Special device with adjustable electric motor allows to change infinitely the magnitude of feed and turn of tube from the control desk.

By means of equipment unification at the enter side with mills for cold tubes rolling through rolls developed by VNIIMETMASH ХПТР 8-15 according to customer's wish, it is possible to update them into mills ХПТ 6-15 by separate supply of the mills pass line.

Cooperation proposals:

• Manufacturing of mills ХПТ 6-15;

• Manufacturing of working lines for modernization of mills ХПТР 8-15 into mills ХПТ 6-15;

• Test and mastering of mills ХПТ 6-15 at the customer;

• Organization of joint production.